Termites are loved for their benefits like facilitating decomposition but, are also detested for their habit of destroying valuable property. Most people with hardwood floors complain about termite attack to their floors than those with concrete floors and tiled floors. You can easily avoid termite attacks on your hardwood floors when you follow through the correct procedure of construction. This article will help you prevent risks of damage to your hardwood floors by termites.
The top step in refinishing hardwood floors involves observing the floor and paying more attention to the gaps between the floor planks. Observing between the space can help you identify any signs for termite control. You can notify a termite control expert if you find any signs of termites. You should also be able to observe the type of hardwood floor used to know the care you ought to have while refinishing. The work of refinishing hardwood floors like pine and oak is a lot easier compared to refinishing mahogany, maple and walnut. You can then start refinishing your hardwood floor when you are sure that there are no termites and that you can handle the particular type of hardwood floor.
The next important termite control procedure in refinishing hardwood floors is conducting an adhesion test. Begin by selecting a small area where you will carry out the adhesion test. It involves thoroughly cleaning the floor that you are operating on with a floor cleaner. What follows after that is sanding the area using a sanding screen then clearing the excess residue from the area. The dust-free area is then ready for the application of a coat of polyurethane. You should wait for about twenty-four hours to elapse before checking on the area. The area where you applied termite control polyurethane coating should be polished apart from the few whiskers caused by dust. You can easily know that you are ready to start recoating your floors when you press down on the surface with even and reasonable pressure and the polyurethane does not scrap off.
After the above step, bring together the materials that are essential for termite control your floors. The most of the materials that are necessary are inclusive of the hammer, nail set, pliers, edge sander, box fan, power floor buffer, polyurethane floor sealant, work gloves, hearing protection, breathing protection, industrial grade vacuum cleaner and painter’s tape. You can easily find the aforementioned materials at your neighbors or buy from home improvement store near you or online.
After gathering the materials, clean the floor, carry out buffering and then do the finish. Cleaning helps to termite control the floor so that it becomes spotless. You should change the surface of the sanding screen facing the floor after ten to fifteen minutes because after that it will lose its sanding capability. You should not add the finish unless you have thoroughly cleared off all the dust from the floor. The easiest floor finish option to use is polyurethane.